 |
 |
 |
|
|
|
[Sponsors] | ||||
April 23, 2023, 19:39
|
[expr_mngr] -> Invalid target variable name
|
#1 |
|
New Member
Amin Sheikhi
Join Date: Mar 2023
Posts: 26
Rep Power: 3  |
Hi all,
In simulating a diesel engine and after setting up the spray I always get this error: ----------------------------------------------------------------------------------------- "Expressions manager [expr_mngr] -> Invalid target variable name: injection.injection_control.tot_mass[@]PInjector_3." ----------------------------------------------------------------------------------------- which does not prevent CONVERGE to run and results are fine, i checked total injection mass but again I don't know how to get rid of this error cos it's so annoying after running 200 times. I will be so thankful if you can help me. |
|
|
|
|
|
April 23, 2023, 20:37
|
|
#2 |
|
New Member
Amin Sheikhi
Join Date: Mar 2023
Posts: 26
Rep Power: 3 |
Solved.
how can i delete post? |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem using AMI | vinz | OpenFOAM Running, Solving & CFD | 298 | November 13, 2023 08:19 |
| Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
| error in COMSOL:'ERROR:6164 Duplicate Variable' | bhushas | COMSOL | 1 | May 30, 2008 04:35 |
| Env variable not set | gruber2 | OpenFOAM Installation | 5 | December 30, 2005 04:27 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Linear Mode
