Using file for discharge coefficient error! -- CFD Online Discussion Forums

July 24, 2023, 18:49

Using file for discharge coefficient error!

Amin_

New Member

Amin Sheikhi

Join Date: Mar 2023

Posts: 26

Rep Power: 3

Hi everyone,

I want to use varied discharge coefficient, but even by paying attention to the file extension, which should be "in", an error is still given without explanation. Also, using the file for other configurations work properly.

I would be very grateful if you could help me to fix this problem.
Error and configuration attached.

Sincerely,
Amin

Attached Images

	Screenshot (46).jpg (108.1 KB, 14 views)
	Screenshot (47).jpg (107.8 KB, 13 views)

Last edited by Amin_; July 25, 2023 at 07:12.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] Installation Problem with OF 6 version	Aurel	OpenFOAM Community Contributions	14	November 18, 2020 16:18
polynomial BC	srv537	OpenFOAM Pre-Processing	4	December 3, 2016 09:07
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0	Seroga	OpenFOAM Community Contributions	9	June 12, 2015 17:18
OpenFOAM without MPI	kokizzu	OpenFOAM Installation	4	May 26, 2014 09:17
checking the system setup and Qt version	vivek070176	OpenFOAM Installation	22	June 1, 2010 12:34

All times are GMT -4. The time now is 23:39.