CONVERGE

Read this first: How to ask a question on the forums

Page 12 of 24

Threads in Forum : CONVERGE

Rating Thread / Thread Starter	Last Post	Replies	Views
Basic question regarding compression ratio tool magicbretzel	December 18, 2020 12:26 by magicbretzel	3	710
Turbulent Schmidt and Prandtl numbers magicbretzel	February 17, 2024 05:00 by RR06	3	1,860
Temperature extrapolation error magicbretzel	February 16, 2021 14:59 by magicbretzel	3	1,922
Cell pair was created... magicbretzel	February 16, 2021 14:51 by jetcheve	5	1,484
G equation set up MadMaggot	August 16, 2023 03:18 by MadMaggot	2	601
Hanging License madhuvc	August 14, 2018 18:00 by chaighodke	1	1,048
KH enlargement flag for spray modeling M3sh_Master-Ti	May 30, 2023 17:11 by senecal	1	479
Non-newtonian fluid atomization simulation M3sh_Master-Ti	January 25, 2024 09:48 by M3sh_Master-Ti	7	433
Twin-fluid Atomization M3sh_Master-Ti	January 3, 2024 03:16 by M3sh_Master-Ti	4	323
Contraction coefficient in atomization M3sh_Master-Ti	January 26, 2024 13:54 by ksrivast	3	230
Error in VOF simulation M3sh_Master-Ti	March 8, 2024 07:43 by angela.wu	4	235
VOF simulation with no fluid M3sh_Master-Ti	March 8, 2024 03:26 by M3sh_Master-Ti	2	196
Contact angle in wall adhesion model in VOF simulation M3sh_Master-Ti	March 17, 2024 10:28 by M3sh_Master-Ti	2	215
VOF simulation of twin fluid atomization M3sh_Master-Ti	March 20, 2024 02:52 by M3sh_Master-Ti	2	196
Peak Pressure way to low in SI IC engine case - SAGE m102.992	April 4, 2022 17:10 by m102.992	0	666
parcel simulation lxh	April 27, 2023 15:54 by arajendran	1	547
How to spray gas-fuel in converge luckyboy	March 1, 2017 08:47 by whysoserious	7	2,517
can not began luckyboy	June 9, 2017 21:43 by luckyboy	2	792
initial condition luckyboy	July 24, 2017 05:14 by luckyboy	4	964
error:upper_energy_value must be greater than lower_energy_value luckyboy	July 25, 2017 10:26 by luckyboy	5	1,344
cmd header luckyboy	April 11, 2019 07:53 by MJLiu	3	1,520
abbreviation of fuel is supported ? luckyboy	September 18, 2017 22:28 by luckyboy	2	755
calculate slowly luckyboy	September 20, 2017 04:57 by luckyboy	5	966
pressure increase sharply luckyboy	September 25, 2017 07:59 by luckyboy	11	972
multi-fuel case can't ignition luckyboy	September 30, 2017 03:33 by MFGT	7	976
Why will hydrogen go out in compression ignition luckyboy	March 19, 2018 13:33 by nitesh.attal	3	1,160
No heat release in a simulation luckyboy	April 30, 2018 14:46 by Dan.Maciejewski	1	1,092
could not find a side polygon that surrounds the negative area side polygon luckyboy	May 16, 2019 22:29 by Jammie Law	7	1,659
mass flow luckyboy	May 14, 2018 21:38 by luckyboy	2	1,084
heat release increase suddenly luckyboy	August 3, 2018 08:42 by MFGT	1	1,031
hydrogen injection luckyboy	January 3, 2019 06:56 by mohsinmkhan	5	1,307
make udf files luckyboy	December 10, 2018 09:58 by tmburton	7	1,577
make udf luckyboy	January 17, 2019 05:50 by luckyboy	5	1,150
FFT:Frequency-Amplitude plot luckyboy	May 25, 2019 06:19 by luckyboy	2	1,340
G-equation model ignition failed luckyboy	September 13, 2021 09:42 by wfxdlut@163.com	9	1,339
warning:Dij_inv is too small luckyboy	November 2, 2021 10:08 by luckyboy	4	716
JOB ABORT invoked by rank 17 ltl	January 25, 2021 15:05 by nitesh.attal	3	2,897
ERROR: Safe Malloc has detected a null pointer ltl	April 7, 2021 14:00 by jetcheve	5	1,112
species are missing within thermo.dat ltl	August 16, 2023 13:30 by Totoralio	3	955
Calculation speed ltl	August 1, 2022 17:19 by Xiao Ren	1	552

Read this first: How to ask a question on the forums

Page 12 of 24

« First

Last »

	New posts		Hot thread with new posts
	No new posts		Hot thread with no new posts
	Thread is closed

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -4. The time now is 02:53.