 |
 |
 |
|
|
|
[Sponsors] | ||||
January 25, 2018, 02:51
|
Solenoid simulation in MAXWELL
|
#1 |
|
New Member
Choose Country Then State
Join Date: Jan 2018
Posts: 2
Rep Power: 0  |
I am simulating a typical simulated by Maxwell software.
In the first step I simulated a solenoid with air core. The results corresponds with theorical simulations. When I replaced the air core with a ferrite, theorical calculation reveals that H field should be the same as previus while B field increases with the respect to mu_r value, but the software results is not like this. In the simulation results, H decreases and B increases but not with respect to mu_r. In both cases the excitation current is the same. Can you help me to find the problem? Regards |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solenoid simulation in CST EM studio | MAYH | Electromagnetics | 0 | January 23, 2018 13:18 |
| Surface Source - Fixed Temperature? | robtheslob | FloEFD, FloWorks & FloTHERM | 18 | May 12, 2017 02:28 |
| Simulation FPEs - turbulence for transient and steady-state? | DaveR | OpenFOAM Running, Solving & CFD | 5 | March 5, 2017 15:06 |
| calculate the inductance of a thick solenoid by ansys Maxwell | brahim2016 | Electromagnetics | 0 | May 21, 2016 01:48 |
| Simulation of high pressure diesel injector - all phases compressible with cavitation | fivos | CFX | 4 | July 30, 2015 06:48 |
Linear Mode
