Create probe on Ensight -- CFD Online Discussion Forums

November 28, 2021, 06:48	Create probe on Ensight	#1
fathi12 New Member fathi Join Date: Nov 2021 Location: Tunisia Posts: 1 Rep Power: 0	Good morning I'm using Ansys-Ensight for IC engine post-process. I would find out the pressure value within a specific point on the piston as a function of time since a dynamic mesh is in use . The probe at the specific point should be varied with mesh (Time+coordinates). Could you please help me find how to link a point within a mesh? Thank you

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Viscoelastic Fluid Flows using OpenFOAM The solver viscoelasticFluidFoam	jovani	OpenFOAM Running, Solving & CFD	475	January 13, 2023 08:21
[gmsh] How to create a 3D volume mesh using a existing surface mesh?!	RobertHB	Mesh Generation & Pre-Processing	0	July 20, 2017 08:12
[ICEM] how to create a 2d tri mesh with quad mesh in the boundary layer	seal2013	ANSYS Meshing & Geometry	3	October 6, 2013 16:09
create a probe with fluent	Aenseeiht	FLUENT	3	April 29, 2010 03:27
Actuator disk model	audrich	FLUENT	0	September 21, 2009 07:06

All times are GMT -4. The time now is 00:46.