|
[Sponsors] |
October 5, 2014, 04:10 |
Solid Patch Under Trimming Part
|
#1 |
New Member
Lim Pei San
Join Date: Mar 2014
Posts: 25
Rep Power: 12 |
Hi,
May i know is that possible to have solid patch (transom) under trimming part in adapt to geometry section? Because it show different from in tutorial which only consist external and mirror patches. I think this reason has cause me get inaccurate data. Is it the geometry problem? Any suggestion or idea about it? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
createPatch Segmentation Fault (CORE DUMPED) | sam.ho | OpenFOAM Pre-Processing | 2 | April 21, 2014 02:01 |
[Gmsh] Single volume Mesh gmsh | PeteH | OpenFOAM Meshing & Mesh Conversion | 9 | August 6, 2013 08:54 |
Algorithme choosing for solid part analysis of conjugate heat transfer | Anna Tian | Main CFD Forum | 4 | January 20, 2013 16:11 |
Cyclic Boundary Condition | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Running, Solving & CFD | 36 | July 2, 2012 12:23 |
chtMultiRegionFoam Tutorial | m.nichols19 | OpenFOAM | 12 | September 9, 2010 11:56 |