|
[Sponsors] |
May 4, 2018, 03:43 |
Generate mesh in NUMECA/Design2D
|
#1 |
New Member
YouweiHe
Join Date: May 2018
Posts: 2
Rep Power: 0 |
I'm going to do a 2D flow analysis of a profile of a compressor blade using FINE/Design2D.
I followed the steps in user manual. However it is prompted that there is no grid file associated. But I did not find a mesh generate button in the GUI. So, would anyone tell me how to generate mesh in FINE/Design2D? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[ICEM] How to generate this kind of mesh? | mingersai | ANSYS Meshing & Geometry | 51 | February 16, 2017 07:32 |
How to generate a Cartesian 2D Mesh using MATLAB? | sujithsubramanian | Main CFD Forum | 0 | March 9, 2014 15:46 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[snappyHexMesh] SnappyHexMesh not generate mesh first time | mavimo | OpenFOAM Meshing & Mesh Conversion | 4 | August 26, 2008 07:08 |