FloEFD for Aerodynamic Forces

Chris Kriel · March 6, 2016, 21:37

Hi,

Does anyone have experience using FloEFD/SW Flow to determine aerodynamic/wind forces on structures/towers/components? As far as I know the k-e turbulence model is well suited for this application, and I believe FloEFD/SW Flow should be well suited for this. Just wanted to know if there are any users out there who has done this and obtained good results?

Thank you,
Chris

Boris_M · March 7, 2016, 07:22

Hi Chris,

yes, the results match very good. There are a range of applications I have seen for such cases. This one for example used FloEFD to analyze the forces and pressure coefficients on gas station roof structures:
http://phdtree.org/pdf/25907894-anal...ts-under-wind/

Unfortunately I cannot share the paper if you cannot find it somewhere on the internet.

Here is another one that doesn't show any loads but the velocity in a city model:
http://digitaleplannen.apeldoorn.nl/...16-ont1_10.pdf

I hope this helps,
Boris

Chris Kriel · March 9, 2016, 03:23

Hi Boris,

Thank you, the 1st article is helpful.

Chris

March 6, 2016, 21:37	FloEFD for Aerodynamic Forces	#1
Chris Kriel New Member Chris Kriel Join Date: Oct 2013 Posts: 4 Rep Power: 12	Hi, Does anyone have experience using FloEFD/SW Flow to determine aerodynamic/wind forces on structures/towers/components? As far as I know the k-e turbulence model is well suited for this application, and I believe FloEFD/SW Flow should be well suited for this. Just wanted to know if there are any users out there who has done this and obtained good results? Thank you, Chris

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Reading forces from previous time step within solver	SD@TUB	OpenFOAM Programming & Development	5	April 24, 2023 11:51
Pressure and density values to compute forces	fernexda	OpenFOAM Post-Processing	2	March 6, 2015 03:39
Forces for airfoil test case	Martin_	OpenFOAM Running, Solving & CFD	1	July 2, 2012 11:58
FORCES don't run!	C12Carbon	OpenFOAM	0	September 10, 2011 07:34
Valve Forces in CFdesign	Mike Clapp	Main CFD Forum	3	March 8, 2001 14:09

March 7, 2016, 07:22		#2
Boris_M Disabled Join Date: Jul 2009 Posts: 616 Rep Power: 23	Hi Chris, yes, the results match very good. There are a range of applications I have seen for such cases. This one for example used FloEFD to analyze the forces and pressure coefficients on gas station roof structures: http://phdtree.org/pdf/25907894-anal...ts-under-wind/ Unfortunately I cannot share the paper if you cannot find it somewhere on the internet. Here is another one that doesn't show any loads but the velocity in a city model: http://digitaleplannen.apeldoorn.nl/...16-ont1_10.pdf I hope this helps, Boris

March 9, 2016, 03:23		#3
Chris Kriel New Member Chris Kriel Join Date: Oct 2013 Posts: 4 Rep Power: 12	Hi Boris, Thank you, the 1st article is helpful. Chris