Setting a PCB board background heat load -- CFD Online Discussion Forums

June 10, 2016, 08:25	Setting a PCB board background heat load	#1
hugolol New Member Hugo Join Date: May 2016 Posts: 2 Rep Power: 0	Hi! I'm currently doing an analysis of an sealed electronic appliance in FloTHERM XT. In the FloEDA Bridge, I've filtered out all the smaller components and put a power on the other bigger ones. However, I want to put a background power on the PCB to compensate for the filtered smaller components, is this possible, or do you have any suggestion on how to do this? Thanks, Hugo

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the height of the stream in the free channel	kevinmccartin	CFX	12	October 13, 2022 21:43
using chemkin	JMDag2004	OpenFOAM Pre-Processing	2	March 8, 2016 22:38
Fluent background setting problem....	bharath	FLUENT	2	July 18, 2013 21:05
how to load the heat source to wall	david yang	Main CFD Forum	1	October 12, 2009 13:34
Heat load from Radiation	Jens	CFX	4	September 3, 2002 01:44

All times are GMT -4. The time now is 04:57.