|
[Sponsors] |
December 10, 2018, 23:00 |
Transient in Flowtherm 11.3
|
#1 |
New Member
Join Date: Dec 2018
Posts: 1
Rep Power: 0 |
Hello Experts,
I'm a newbie for Flowtherm software. 3 questions here: 1) I face a difficulty to judge which condition (steady state or transient state) setting i should set for my project. Project condition: one main PCB is place inside plastic enclosure with a small opening hole which allow air room to flow in with speed 0.65m/s. 2)initially, I'm using steady state setting to solve this project yet i failed to obtain converged result with couple tried. Oscillating profile obtained during steady state setting. So, i decided to have a try on transient analysis setting. With Transient analysis, i obtain a message window write on " Solver stopped: all monitor points are stable" after done the simulation. Does this mean of "converged"? Picture is attached. Transient setting: increasing power with 1.1 index in 3600s 3) continue question 2, if it is not converge, does it because of the temperature residual is not stable (still hanging and not yet reach zero) as shown in pic attached? How am i going to solve this problem? Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient simulations: how to tell its converged (I've read the FAQ & user guides!) | JuPa | CFX | 12 | March 27, 2020 17:24 |
Large transient ".trn" files when doing time average | dtmith | CFX | 2 | June 28, 2015 09:06 |
Transient Statistics Results in CFD Post | ashtonJ | CFX | 2 | October 27, 2014 06:48 |
Transient or Transient Blade Row? | liucheng8602 | CFX | 2 | June 19, 2014 07:03 |
Best practice for transient simulations? | siw | CFX | 5 | October 30, 2010 05:45 |