|
[Sponsors] |
April 21, 2008, 08:30 |
There is no fluid volume in the project
|
#1 |
Guest
Posts: n/a
|
Hello
When I start the simulation or just create mesh I have the message: "There is no fluid volume in the project. Please check geometry or boundary conditions." It's an external analysis type with conduction, radiation and free air cooling. I often make this type of simulation and I was never obtained this message. Remark: -If I run this model in internal analysis type with heat conduction in solids only it's OK. - I check geometry and I have: "Analysis type: External" "The fluid volume is 0 m^3" "The solid volume is 0,06264 m^3" Thanks in advance for any help! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
How to create a fluid volume inside a solid volume | sanin | FLUENT | 4 | November 13, 2008 15:17 |
How to apply negtive pressure to outlet | bioman66 | CFX | 5 | June 3, 2006 01:40 |
Information required on Fluid bed project | M Choudhury | Main CFD Forum | 0 | October 8, 1998 05:52 |