|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hello ,im having a hard time conducting an external analysis,heres the error message that i get when i try to run the analysis "There is no fluid volume in the project. Please check geometry or boundary conditions",before i start the project i have nonzero solid volume but after i use the wizard i get zero solid and nonzero fluid volume in geometry check and the analysis wont run and i get the message i mentioned above,although with internal analysis everything works just fine and the analysis runs smoothly,i should mention that i already checked invalid contacts and theres non ,was wondering if anyone could help me out,any help would be appreciated TY
![]() |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 22:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |