 |
 |
 |
|
|
|
[Sponsors] | ||||
July 9, 2014, 10:03
|
Water cooling and centrifugal casting
|
#1 |
|
New Member
Join Date: Jun 2014
Posts: 3
Rep Power: 12  |
Hi everyone,
I am trying to simulate a centrifugal casting problem. I use the GMO to do so and now I want to add water cooling. I read in the user guide that cooling channels are not available for GMO. Is there any other way I can simulate this? My rotating mould is continuously sprayed with water jets from the outside. Many thanks, Nils |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multi-phase flow in centrifugal oil separator | alenp07 | FLUENT | 1 | June 20, 2012 09:51 |
Linear Mode
