 |
 |
 |
|
|
|
[Sponsors] | ||||
February 14, 2016, 11:04
|
different solutions for the same problem!
|
#1 |
|
Senior Member
Join Date: Oct 2014
Posts: 124
Rep Power: 11  |
Hello,
I am simulating a very low speed turbine (transient simulation, VOF model). I run the simulation and monitor the torque at the shaft. Then, I have re-run again the same simulation, identycal, with the same conditions, discretization, ect. The results (the shaft torque) has changed of 20-25%...very strange..It does not happen always, only few times, but it is strange. Do you know why? Caos? Thank you |
|
|
|
|
| Tags |
| different solution, transient, turbine, vof |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
| Problem with interFoam; Wave/wiggle alpha1 behavior | JonW | OpenFOAM | 10 | February 4, 2023 07:27 |
| conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 08:39 |
Threaded Mode
