|
[Sponsors] |
September 18, 2017, 04:31 |
Critical Heat Flux in a Pipe
|
#1 |
New Member
ChenChong
Join Date: Jul 2017
Posts: 7
Rep Power: 8 |
Hello,I have some problems about" Fluid Dynamics Verification Manual" VMFL067 Boiling in a Pipe-Critical Heat Flux,the problem described as follow Figures .I have just simulated the case base on the introduction,and all the conditions and models are consistent,the inlet temperature is 555k. but I can not get the same result.I used the Boiling model-critical heat flux,turbenlent model:RNG k-e.The calculated wall temperature distribution show as follow figure.Have someone ever done this case? Beg for your help! Thank you!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Conjugate Heat Transfer: Wall Heat Flux at Coupled Walls? | MaxHeat | FLUENT | 4 | September 14, 2017 10:44 |
Heat Flux Profile at Fluid-Porous Interface | Hitch8 | CFX | 4 | December 15, 2012 09:57 |
Heat Flux , Convective + Radiant Heat flux | Mandeep | CFX | 3 | October 25, 2012 16:57 |
Heat Flux at wall in a conjugate heat transfer problem | Chander | CFX | 2 | July 9, 2011 22:22 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |