|
[Sponsors] |
June 16, 2020, 00:57 |
Is there a way to rotate the patched region?
|
#1 |
New Member
Shuyan
Join Date: Feb 2020
Posts: 8
Rep Power: 6 |
Hi,
I am doing a simulation with water and vapor involved. I am looking for advice on how to rotate the patched region (image attached), or to create another region that is not defined by x,y rectangular coordinates. Previously I have no issues patching the water region into my simulation as it was vertically upright. Now, with the addition of an inclination angle, I am lost. Sincere apologies if this was a simple question! Shu Yan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can I use fvOptions to couple a solid region and a fluid region? | titanchao | OpenFOAM Running, Solving & CFD | 4 | January 14, 2022 07:55 |
Maximum number of iterations exceeded chtmultiregionsimpleFoam | Moncef | OpenFOAM Running, Solving & CFD | 28 | July 13, 2020 14:26 |
p_rgh initial residual no change with different settings | manuc | OpenFOAM Running, Solving & CFD | 3 | June 26, 2018 15:53 |
HeatSource BC to the whole region in chtMultiRegionHeater | xsa | OpenFOAM Running, Solving & CFD | 3 | November 7, 2016 05:07 |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |