[o_mars_2010]

I have a simulation of the toilet flushing process.
The simulation have been done on both ANSYS Fluent & COMSOL Multiphysics.


I captured a snapshot of the simulation at the same time from both programs.
On ANSYS the water is flowing down in layers, while in COMSOL the fluid exit like a Jet.


Could you please help me to find what is causing such a difference.
Fluent simulation is based on VOF, while COMSOL is based on Level of Set.


Both simulation are turbulent with realizable k-e model.

[cae]

the contact angle on the wall? In Comsol, you set 90degrees. But in fluent, like 150?