|
[Sponsors] |
March 1, 2014, 06:36 |
6DOF solver and specifications
|
#1 |
New Member
Jakob Hærvig
Join Date: Sep 2012
Location: Aalborg, Denmark
Posts: 27
Rep Power: 13 |
Hi,
I am to model a flat aluminium plate falling freely under gravity in water in 2D. The plate has a length of 50 mm and a height of 2.5 mm (1 m in z-direction?). I've been looking at the Fluent userguide: SDOF_MASS /* mass */ SDOF_IXX, /* moment of inertia */ SDOF_IYY, /* moment of inertia */ SDOF_IZZ, /* moment of inertia */ SDOF_IXY, /* product of inertia */ SDOF_IXZ, /* product of inertia */ SDOF_IYZ, /* product of inertia */ But no matter how I specify the moment of inertia, the plate does not seem to rotate the way it should. I'm comparing with a simple numerical model based on lift and drag coefficients. Does anyone know how to specify the properties correctly? Best regards, Hrvig |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary Conditions and solver for low Mach laminar air jet | fbisetti | OpenFOAM Running, Solving & CFD | 1 | September 13, 2006 12:49 |