 |
 |
 |
|
|
|
[Sponsors] | ||||
problem in simulating adding nanoparticle to PCM |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 28, 2018, 17:00
|
problem in simulating adding nanoparticle to PCM
|
#1 |
|
New Member
None
Join Date: Jun 2016
Posts: 1
Rep Power: 0  |
hello everyone, i'm trying to write udf for thermal conductivity coefficient in adding nanoparitcle to PCM. its all ok and no error happens. temperature also increases well in early times. but when my PCM reaches melting point, temperature does not increases and it stop at melting point. anybody have any solution??
thank |
|
|
|
|
|
| Tags |
| nanoparticle, pcm modeling, udf define property |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PDF table- species adding problem | shookybal | FLUENT | 1 | October 21, 2019 10:04 |
| Problem simulating katabatic winds | Arcannys | Main CFD Forum | 0 | January 25, 2017 17:18 |
| FLUENT adding mesh nodes problem when importing 3D mesh from ICEM | guxin7005 | FLUENT | 2 | June 27, 2016 21:41 |
| Problem simulating a reactor inlet area using rhoReactingFoam | hester | OpenFOAM Running, Solving & CFD | 0 | September 3, 2014 10:10 |
| Problem adding a source term in interfoam's alphaEqn.H | Quentin | OpenFOAM Running, Solving & CFD | 1 | July 30, 2014 05:33 |
Linear Mode
