Simulating open channel flow in ANSYS Fluent

openchannelflow · May 29, 2012, 23:01

Hi all
I am attempting to model a simple 2D simulation of open channel flow over a bump. Does anyone know of any good tutorials/walkthroughs to help me with this please?
Thank you

delaneyluke · May 30, 2012, 05:03

If you have access to the FLUENT support website, you'll get the tutorial there.
Else I could send it to you

Regards
Luke

openchannelflow · May 30, 2012, 06:10

I am using it on a university computer so I don't know the customer number etc.
What kind of tutorial is it? Do you mind sending it please?
Many thanks

BalJay · September 27, 2013, 14:25

Hi, also new to using Fluent and trying to model open channel flow about a flat plate. Is there a useful tutorial available?

May 29, 2012, 23:01	Simulating open channel flow in ANSYS Fluent	#1
openchannelflow New Member Anonymous van Munster Join Date: May 2012 Posts: 2 Rep Power: 0	Hi all I am attempting to model a simple 2D simulation of open channel flow over a bump. Does anyone know of any good tutorials/walkthroughs to help me with this please? Thank you

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boundary condition problem for open channel flow	Andy	CFX	9	June 11, 2016 07:20
open channel flow: pressure-inlet	jack1980	FLUENT	1	October 21, 2012 14:15
Yacht in Open Channel Flow	andreimour	FLUENT	1	October 14, 2010 23:54
Open Channel Flow using InterFoam type solver	sxhdhi	OpenFOAM Running, Solving & CFD	3	May 5, 2009 21:58
Two-phase open channel flow	Edwin	FLUENT	3	July 11, 2006 02:21

May 30, 2012, 05:03		#2
delaneyluke Senior Member Join Date: Mar 2009 Location: Indiana, US Posts: 186 Rep Power: 18	If you have access to the FLUENT support website, you'll get the tutorial there. Else I could send it to you Regards Luke

May 30, 2012, 06:10		#3
openchannelflow New Member Anonymous van Munster Join Date: May 2012 Posts: 2 Rep Power: 0	I am using it on a university computer so I don't know the customer number etc. What kind of tutorial is it? Do you mind sending it please? Many thanks

September 27, 2013, 14:25		#4
BalJay New Member Join Date: Sep 2013 Posts: 1 Rep Power: 0	Hi, also new to using Fluent and trying to model open channel flow about a flat plate. Is there a useful tutorial available?