|
[Sponsors] |
June 20, 2012, 05:14 |
Simulation of a brick
|
#1 |
Member
Join Date: Sep 2010
Posts: 60
Rep Power: 15 |
I have a 3D brick (10cm*10cm*10cm) open of the top face and other feces represents walls. I want to fill with water to a hof the faceeight of 2cm only, how can I do to set the water level in my brick?
Is what I defined the mesh inside the brick's intill my desired level of water? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why my simulation not agree with the wind tunnel experiment | zhaowei | CFX | 4 | July 11, 2015 03:36 |
Solar Radiation in OpenFOAM | plainstyle | OpenFOAM Running, Solving & CFD | 15 | July 8, 2014 04:43 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 10:44 |
Continuous vs interrupted simulation | sega | OpenFOAM Running, Solving & CFD | 4 | November 3, 2008 14:29 |
strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 13:02 |