|July 21, 2012, 09:36||
Divergence of structured mesh
I have been trying to simulate flow conditions on a 3D wing. Its successful with unstructured mesh (to a large extent) but when i try the same with structured mesh, the flow is diverging immediately after a few tens of iterations. I eliminated almost all sudden variations in grid size as much as possible and it still exists.. As of now i am completely out of ideas. So pls kindly pour in as many suggestions as possible.
I have uploaded the .tin and .blk files for you to check the mesh. In case of contours from fluent, pls mention the one you require and i will post it immediately.
The below link contains the mesh files..
|divergence, scalloped wing, structured mesh|
|Thread||Thread Starter||Forum||Replies||Last Post|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||6||August 26, 2015 09:38|
|[ANSYS Meshing] 3D Multiblock Structured Hexahedral Mesh||zeo||ANSYS Meshing & Geometry||25||February 5, 2015 00:03|
|Block structured hexagonal mesh vs automated tetra mesh inside Workbench for CFD||Chander||CFX||3||November 27, 2011 17:24|
|[ICEM] Problem making structured mesh on a surface||froztbear||ANSYS Meshing & Geometry||4||November 10, 2011 09:52|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 12:55|