 |
 |
 |
|
|
|
[Sponsors] | ||||
How to create a bevel in FLUENT by patch for something else? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 30, 2012, 10:46
|
How to create a bevel in FLUENT by patch for something else?
|
#1 |
|
New Member
Zhonghai Xu(xuzhonghai@sjtu.edu.cn)
Join Date: Apr 2012
Location: Shanghai,CHINA
Posts: 17
Rep Power: 14  |
Hello,I want to create a 2D model which can simulate water motion.I used ICEM CFD ,and split the surface which represents the fluid environment.As you can see in the attachment,I create a part named "AIR"and the another part named "WATER" ,a part "INTERFACE".But when I loaded the mesh file into the FLUENT,there just exists only one fluid zone! I use the Adapt-->Region... and Mark,then,Adapt-->Manage...and Display,the mesh disappeared from the screen!I don't konw what's the problem,and how can I create a bevel,someone told me use the patch,who can help me ?
model:VOF ; k-e;。。。 Thanks in advance! realstoneman |
|
|
|
|
|
August 30, 2012, 12:27
|
Anyone can help me?
|
#2 |
|
New Member
Zhonghai Xu(xuzhonghai@sjtu.edu.cn)
Join Date: Apr 2012
Location: Shanghai,CHINA
Posts: 17
Rep Power: 14 |
Anyone can help me?
Thanks a lot! |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| Ansys 12.1 - Create Rotor/Stator Interface for Fluent | opm | ANSYS Meshing & Geometry | 21 | May 23, 2016 08:29 |
| Create a GeometricField of a given type on given patch? | philippose | OpenFOAM Programming & Development | 4 | August 12, 2013 12:41 |
| [snappyHexMesh] How to create a separate patch on a blockmesh surface | bing.guo | OpenFOAM Meshing & Mesh Conversion | 0 | April 24, 2011 11:35 |
| create a probe with fluent | Aenseeiht | FLUENT | 3 | April 29, 2010 03:27 |
Linear Mode
