|
[Sponsors] |
December 1, 2012, 15:39 |
problem in microchannel
|
#1 |
New Member
ammm
Join Date: Nov 2012
Posts: 21
Rep Power: 13 |
hi friends
i simulate a t shape micro reactor with fluent .cross section of it is 0.8*1 mm^2 and and i setpressure outlet =0 and velocity inlet for it . flow is laminar and fluid is liquid-water. but when i compare exprimental data and simulation data i see a big error . simulation data is very smaller than exprimental data and there is different in pressure and other things sound correct what should i do??? please help me . its very important for me thank you in advance |
|
December 2, 2012, 15:44 |
|
#2 |
New Member
ammm
Join Date: Nov 2012
Posts: 21
Rep Power: 13 |
come on please
i need your helps |
|
December 3, 2012, 17:22 |
|
#3 |
New Member
Valentin
Join Date: Dec 2012
Posts: 4
Rep Power: 13 |
Whats kind of error? What did you measure in the experiment. There can be a lot of reasons.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with interFoam; Wave/wiggle alpha1 behavior | JonW | OpenFOAM | 10 | February 4, 2023 07:27 |
PROBLEM REGARDING MICROCHANNEL HEAT SINK | SHAKUNTALA OJHA | FLUENT | 3 | May 27, 2008 12:14 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |