Home > Forums > Software User Forums > ANSYS > FLUENT

3d circular finned tube

Mark Forums Read

Reply

Search this Thread

December 18, 2012, 06:01	3d circular finned tube	#1
student1 New Member satvik Join Date: Dec 2012 Posts: 1 Rep Power: 0	hii,, i'm doing my project using gambit and fluent. i've modelled circular finned tube in gambit and exported it to fluent. i've also run the simulation in fluent but i'm having a slight problem. Conduction from the wall of the tube to the fins are not taking place. i got the temperature distribution inside the fluid properly. can anyone help me with this..

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Finned tube Hexa mesh	aliemadi	ANSYS Meshing & Geometry	5	May 14, 2012 20:58
Heat transfer in circular tube with constant wall heat flux	ali radwan	ANSYS	0	August 30, 2010 21:30
Finned Tube "Virtual wind Tunnel"	anupbkc	Phoenics	0	July 28, 2009 11:39
Finned tube Modelling	csmistry	CFX	1	July 5, 2009 07:49
emptying liquid from spinning circular tube	uvce	Main CFD Forum	0	July 2, 1999 11:26

All times are GMT -4. The time now is 11:26.