|
[Sponsors] |
January 15, 2013, 11:12 |
How can I place the slab inside the furnace?
|
#1 |
New Member
Tiago Morgado
Join Date: Dec 2012
Posts: 8
Rep Power: 13 |
I want to simulate a transient heat transfer of metal slab inside a re-heating furnace, but I want to do this starting from a converged steady-state simulation of an empty furnace.
How can I place the slab ( a solid cell zone ) inside the empty furnace (a fluid cell zone domain) after finishing the converged steady-state simulation? Thanks in advance |
|
Tags |
cell zones, furnace, transient conduction |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Simulate transient heating of a slab in a furnace | TMorgado | Fluent UDF and Scheme Programming | 0 | December 6, 2012 18:41 |
Skipping zone inlet (not referenced by grid) | vinoo | FLUENT | 7 | February 18, 2010 19:05 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Heating of a metal piece inside a furnace | CFDguy | FLUENT | 2 | September 5, 2008 08:41 |
meshing F1 front wing | Steve | FLUENT | 0 | April 17, 2003 12:37 |