chilled water storage simulation

windy2012 · February 4, 2013, 04:01

hi everyone ,i am filling a tank (radius=10m,height=20m)with 4℃water，the tank was full of 12℃water at first.max grid interval is 20mm,max time interval is 2s. charing time is 7hours,i calculated the velocity ,but after 7hours,there are only 70% of the tank is 4℃water,although thermocline forms ，there are still about 15 of rest water is 12℃，any one can tell me where is wrong?

btw，the model is 2d,there are two inlet holes in the bottom ,and two outflow holes in the top .lenth is 0.015m

msaeedsadeghi · February 5, 2013, 01:33

It should not a stiff problem.
- Have you enabled gravity?
- Have you enabled surface tension?
- Have you enabled incompressible density?
- Which multiphase model are you using?

February 4, 2013, 04:01	chilled water storage simulation	#1
windy2012 New Member hd Join Date: Feb 2013 Posts: 1 Rep Power: 0	hi everyone ,i am filling a tank (radius=10m,height=20m)with 4℃water，the tank was full of 12℃water at first.max grid interval is 20mm,max time interval is 2s. charing time is 7hours,i calculated the velocity ,but after 7hours,there are only 70% of the tank is 4℃water,although thermocline forms ，there are still about 15 of rest water is 12℃，any one can tell me where is wrong? btw，the model is 2d,there are two inlet holes in the bottom ,and two outflow holes in the top .lenth is 0.015m Last edited by windy2012; February 4, 2013 at 04:35.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Looking for information for simulation of explosion in deep water or enclosed space	richard	FLUENT	6	January 6, 2016 03:06
cold storage simulation of 2 tr capacity	Ravi Kharde	CFX	1	May 6, 2011 09:17
simulation of water flow though a ducted propeller	spacewatcer	FLUENT	0	April 22, 2009 10:52
simulation with 2 fluids: air and water	Rogerio Fernandes Brito	CFX	4	March 20, 2008 19:07
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 10:11

February 5, 2013, 01:33		#2
msaeedsadeghi Senior Member SSL Join Date: Oct 2012 Posts: 226 Rep Power: 16	It should not a stiff problem. - Have you enabled gravity? - Have you enabled surface tension? - Have you enabled incompressible density? - Which multiphase model are you using?