|
[Sponsors] |
February 8, 2013, 03:24 |
fluent autosave?
|
#1 |
Member
Thomas Hoffmann
Join Date: Oct 2012
Posts: 67
Rep Power: 13 |
Hi
I'm running Fluent through workbench. If I run a simulation for 100 iterations and save before I close fluent and then open fluent again, then the calculations are not saved. Even though I click save project before I close fluent, it only saves the setup and not the iterations that I carried out before I closed fluent last time.. Anybody who knows how to make it save properly, so I can do further iterations when I open up fluent? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
Error in reading Fluent 13 case file in fluent 12 | apurv | FLUENT | 2 | July 12, 2013 07:46 |
On Autosave Fluent Hangs | nirupam | FLUENT | 1 | September 6, 2007 14:06 |
Fluent 5.2.3 autosave? | Ricky Wong | FLUENT | 1 | March 24, 2000 15:36 |