Home > Forums > Software User Forums > ANSYS > FLUENT

How to merge passages?

Updated Threads

Reply

Search this Thread

February 15, 2013, 08:02	How to merge passages?	#1
oringo New Member Marek Join Date: Feb 2013 Posts: 6 Rep Power: 13	Hello everyone, I'd like to make a CFD simulation of pump impeller in fluent. I made mesh in the TurboGrid v13. The problem is that impeller will be connected with the volute so I need full impeller mesh not only 1 passage (6 blades=6passages). How can I get full mesh? I've tried use merge in fluent I merged zones but I don't know how I should connect them in 1 mesh and don't have interface between passages. Now I have wall between passages. How can I delete that face and get 1 mesh of whole impeller in fluent? Should I use other programs (eg. ICEM)? Best wishes, Marek

Reply

Tags

fluent, impeller, merge mesh

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problem when I try to merge hexa & prism	pipolaki	ANSYS Meshing & Geometry	7	December 4, 2012 08:44
[ICEM] Merge mesh - non manifold vertices	BrolY	ANSYS Meshing & Geometry	4	October 30, 2010 22:07
assemble the mesh	feixiangniao	ANSYS Meshing & Geometry	2	March 20, 2010 02:39
about merge mesh	lian	Main CFD Forum	3	February 29, 2008 10:47
bolt air passages design	Eric JAOUEN	Main CFD Forum	0	July 25, 2003 08:47

All times are GMT -4. The time now is 23:56.