 |
 |
 |
|
|
|
[Sponsors] | ||||
February 19, 2013, 11:09
|
Diverge with Radiation model in HVAC !
|
#1 |
|
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 13  |
Hello everyone.
I should use radiation model in a case in order to set radiation emissivity to the walls. when I run without any radiation model, then I have no problem and I got a very smooth converge. But when I use the radiation model and use P1 or Rosseland, then I got diverge! I try to run without radiation model to have an initial solution, but again I got diverge! I don't know what should I do!! Anybody here knows what is the problem?! Thanks Last edited by asal; February 23, 2013 at 11:48. |
|
|
|
|
|
April 4, 2014, 05:11
|
|
#2 |
|
Member
Maaz Ul Mosaid
Join Date: Jan 2014
Location: Pakistan
Posts: 32
Rep Power: 11 |
Try to refine mesh
|
|
|
|
|
|
|
April 4, 2014, 09:10
|
|
#3 |
|
Senior Member
Flavio
Join Date: Sep 2011
Location: Brescia, Italy
Posts: 181
Rep Power: 15 |
Hello asal,
are you sure that P1 or Rosseland are the best models for your system? Regards
__________________
 Bionico
|
|
|
|
|
|
|
January 27, 2023, 22:36
|
|
#4 | |
|
New Member
Mohammed
Join Date: Aug 2013
Posts: 3
Rep Power: 12 |
Quote:
|
||
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| View factor radiation model. Symmetry boundaries verification.. | Dimoon | OpenFOAM Running, Solving & CFD | 12 | April 6, 2021 03:38 |
| How model radiation of both solid wall and fluid£¿ | Harry Qiu | FLUENT | 2 | February 3, 2013 23:04 |
| P1 radiation model and 2D calculation | autumn1012 | OpenFOAM Running, Solving & CFD | 6 | November 11, 2009 02:52 |
| Help: Radiation model | MANOJKUMAR | FLUENT | 4 | November 24, 2005 02:45 |
| RE: Radiation model | Ashutosh Joshi | FLUENT | 1 | January 30, 2001 10:50 |
Linear Mode
