|
[Sponsors] |
June 30, 2013, 16:33 |
Excessive torque (cm) for 2D vawt
|
#1 |
New Member
Ricardo
Join Date: Jun 2013
Location: u.k.
Posts: 4
Rep Power: 12 |
Hi,
I am simulating a 2D VAWT using a sliding mesh and I get excessive values of torque (cm). Maybe I am defining wrong the values of area, length and depth in the section "Reference Values". Someone can help me? The velocity inlet (wind velocity) is 5 m/s, the angular velocity w= 20 rad/s for a TSR=2. I attached a picture with the measures of the Vawt. Thank you very much. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High torque coefficient Cm for Vertical Axis Wind Turbine (VAWT) | tony00 | FLUENT | 11 | July 23, 2018 06:13 |
Torque calculation of 2D VAWT Wind Turbine | Anonymized_JL1 | FLUENT | 14 | September 26, 2013 03:35 |
Torque Coefficient in a VAWT | Borjinho | FLUENT | 0 | June 19, 2013 10:16 |
Obtaining torque for VAWT | boshank20 | FLUENT | 1 | December 6, 2012 06:00 |
Torque valuation on the shaft of a VAWT | Skywalker | Main CFD Forum | 0 | August 28, 2011 08:32 |