|
[Sponsors] |
Help with heat sink design [2D] Convergence Issue |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 17, 2013, 00:06 |
Help with heat sink design [2D] Convergence Issue
|
#1 |
New Member
Ikhsan
Join Date: Sep 2013
Posts: 15
Rep Power: 12 |
I created a design for heat sink.
I checked the mesh quality in Gambit. The element with the worst aspect ratio value was 2.52411 The element with the worst EquiAngle/EquiSize skew value was 0.475992. From what I understand my meshes are fine, however I am still unable to get convergence after 1000 iterations. Attached the model and mesh quality for reference. What can I do for it to converge? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
Help modeling heat sink | aimee | FLUENT | 1 | June 3, 2011 14:17 |
Forced convection heat transfer in heat sink | Sidy | FLUENT | 1 | October 18, 2008 03:27 |
heat transfer problems of a heat sink | tina | FLUENT | 2 | August 13, 2008 06:11 |
Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |