|September 21, 2013, 08:53||
Join Date: Apr 2013
Posts: 50Rep Power: 6
Hello my friend.
I simulate one long pipe that fluid ( Gas - Methane) flow in.boundary condition are :
inlet: velocity inlet constant velocity 6.85 m/s
constant heat flux at ambient of pipe that is 23100 w/m2
the reference that i use for validation used the outflow boundary condition for outlet. But when i apply this boundary condition (Outflow) the software make warning that 'Maximum Temp. ex. at ****(some digit.) face'.
be mentioned that flow is fully developed at exit.
please help me
|September 21, 2013, 13:05||
Join Date: Jan 2013
Posts: 213Rep Power: 7
You can ignore this warning by increasing solution limit of temperature in the following address:
|Thread||Thread Starter||Forum||Replies||Last Post|
|Domain Imbalance||HMR||CFX||5||October 10, 2016 05:57|
|Radiation interface||hinca||CFX||15||January 26, 2014 18:11|
|Error finding variable "THERMX"||sunilpatil||CFX||8||April 26, 2013 07:00|
|Setting outlet Pressure boundary condition using CAFFA code||Mukund Pondkule||Main CFD Forum||0||March 16, 2011 04:23|
|How exactly the "pressure outlet" bdry condition compute properties on the boundary?||yating9901||FLUENT||3||June 28, 2010 12:26|