|
[Sponsors] |
How can I check process in between start and endpoint? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 21, 2013, 04:23 |
How can I check process in between start and endpoint?
|
#1 |
Member
Tom Marquardt
Join Date: May 2013
Posts: 34
Rep Power: 12 |
Hey Guys,
I have a question, probably pretty stupid, but I could not find a satisfying anwser yet. I have a simulation which lasts 4 hours in real time. It is by any chance possible to simulate these whole 4 hours and check afterwards the process every 30 min? What I did so far was calculating 30 min, stop the simulation, get my data and continue. But I would like to do the whole thing at once and check later...does anyone know if and how this is working? Thanks in advance, would be a life-saver Tom |
|
|
|