|
[Sponsors] |
February 17, 2014, 15:39 |
No slip condition - Sliding mesh
|
#1 |
New Member
dalecooper
Join Date: Jul 2012
Posts: 10
Rep Power: 13 |
Hello,
I am simulating a vertical axis wind turbine, but after i display the contours of velocity near the blades, the velocity is not equal to zero as it should be because of the no slip condition. The measurements of the coefficient moment look ok, but the attached picture does not look as it should. Thanks in advance for any help. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
sliding mesh, confused me, help! help! | weiyang1980 | FLUENT | 2 | September 30, 2009 21:45 |
Slip boundary condition what is inside | normunds | OpenFOAM Running, Solving & CFD | 2 | June 4, 2007 06:45 |
dynamic mesh and sliding mesh | nasser | FLUENT | 0 | November 1, 2005 02:37 |
Sliding Mesh | Sridhar | FLUENT | 0 | August 23, 2002 14:54 |