Error message when set up is run -- CFD Online Discussion Forums

March 23, 2014, 20:52	Error message when set up is run	#1
abhijithmohan New Member Abhijith Mohan Join Date: Mar 2014 Posts: 12 Rep Power: 12	Hi , i am new to Ansys Fluent. Can anyone please tell me what is the reason for the below message.This appeared after modelling in Design modeller and meshing and when 'setup' is loaded. "zone-surface: cannot create surface from sliding interface zone. Creating empty surface."

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[General] 2 datas on one plot	Akuji	ParaView	46	December 1, 2013 14:06
Set inlet boundary conditions in turbulent boundary layer v2f run	kostas	Main CFD Forum	0	March 9, 2012 10:24
Installation problems	indy	OpenFOAM Installation	7	April 3, 2009 09:40
Install Openfoam in Suse 100 setup environment	h34gk1	OpenFOAM Installation	1	September 26, 2006 20:08
Problem installing on 64bit with ver13	jonititan	OpenFOAM Installation	5	May 12, 2006 18:42

All times are GMT -4. The time now is 09:00.