|
[Sponsors] |
May 15, 2014, 22:36 |
Skewness on the higher side
|
#1 |
New Member
Abhijith Mohan
Join Date: Mar 2014
Posts: 12
Rep Power: 12 |
hi, am NEW TO ansys fluent 14. I am doing a simulation on a counter flow heat exchanger. I am getting the shadow walls and conduction occurs across the wall while am giving a coarse mesh. But when i make the mesh finer my solution is no t getting converged. On iterating sometimes it shows "temprature limited to .... (some value)" and iteration goes on .. when I checked the quality of the mesh i found that Skewness and orthogonal quality is out of the allowable limits. How can i correct this?
Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Skewness on the higher side | abhijithmohan | ANSYS Meshing & Geometry | 3 | May 20, 2014 06:50 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Severe nonorthogonality and severe skewness problem | qtian | OpenFOAM Running, Solving & CFD | 2 | January 22, 2008 18:47 |
[Commercial meshers] Converting meshes that includes interfaces | ham | OpenFOAM Meshing & Mesh Conversion | 29 | January 8, 2007 08:58 |