continuously encountering divergence errors in Pressure coupled

Rohitah · June 8, 2014, 18:10

Hi,
I am trying to simulate the coolant flow in the water jacket of the engine using the settings Eulerian, multiphase, boiling, RIP, coupled scheme, Mass flow at inlet.
But I am continuously encountering with the divergence errors in Pressure coupled.

Please help me guys to get rid of it and suggestions are very much appreciated.
Thank you in advance...

sagar457 · January 14, 2015, 03:25

same issue with me...just try reducing under relaxation factor & courant number...in my case it didnt work

maverick123 · January 14, 2015, 04:43

Hello,

Are you running fluent in parallel mode? If yes, try some other partitioning methods.
In past, I faced similar problem. I reduced URFs and ran the case with lesser computing nodes..It worked for me..

Thanks

June 8, 2014, 18:10	continuously encountering divergence errors in Pressure coupled	#1
Rohitah New Member Rohit Sharma Join Date: Jun 2014 Posts: 6 Rep Power: 11	Hi, I am trying to simulate the coolant flow in the water jacket of the engine using the settings Eulerian, multiphase, boiling, RIP, coupled scheme, Mass flow at inlet. But I am continuously encountering with the divergence errors in Pressure coupled. Please help me guys to get rid of it and suggestions are very much appreciated. Thank you in advance...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Divergence detected in AMG solver: pressure correction	xinquanzhoucn	FLUENT	5	July 21, 2014 04:49
Divergence problem	Smaras	FLUENT	13	February 21, 2013 05:03
Help! Divergence detected in AMG solver: pressure correction	user0314	FLUENT	3	September 2, 2011 16:12
Could anybody help me see this error and give help	liugx212	OpenFOAM Running, Solving & CFD	3	January 4, 2006 18:07
what the result is negatif pressure at inlet	chong chee nan	FLUENT	0	December 29, 2001 05:13

January 14, 2015, 03:25		#2
sagar457 New Member sagar Join Date: Nov 2014 Posts: 3 Rep Power: 11	same issue with me...just try reducing under relaxation factor & courant number...in my case it didnt work

January 14, 2015, 04:43		#3
maverick123 Member Join Date: Nov 2014 Posts: 31 Rep Power: 11	Hello, Are you running fluent in parallel mode? If yes, try some other partitioning methods. In past, I faced similar problem. I reduced URFs and ran the case with lesser computing nodes..It worked for me.. Thanks