|
[Sponsors] |
November 1, 2014, 16:45 |
How do I wrap a complex part?
|
#1 |
New Member
Mark
Join Date: Nov 2014
Posts: 21
Rep Power: 11 |
I have a Solidworks model that I must perform CFD on in Fluent. The problem is that the model is made up of Both surface bodies & solid bodies.
I would normally just create the fluid domain (enclosure), & just do a boolean-subtraction. But as my model contains surface bodies, Design Modeler can't calculate a volume to extract. Is there a way that I can 'wrap' the entire surface of the model? An example would be close fitting shrink wrap. This would give me a sealed volume to subtract. I'm working on version 14.0 Any suggections would be appreciated... |
|
Tags |
complex geometry, surface & solid bodies, wrap |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Complex Fields | suniljain | OpenFOAM | 1 | September 12, 2019 08:09 |
[Ansys meshing] Multibody part mesh | ANSYS_user111 | ANSYS Meshing & Geometry | 0 | April 3, 2014 05:51 |
Applying Loads to Part of a Surface/spliting a part in ANSYS | 123catty456 | Main CFD Forum | 1 | July 29, 2013 12:52 |
Complex scalar fields | JamR | OpenFOAM Programming & Development | 0 | July 15, 2013 11:29 |
icem hexa - load different blockings for each part of geometry??? | Catthan | ANSYS Meshing & Geometry | 2 | May 28, 2010 11:27 |