|
[Sponsors] |
November 12, 2014, 16:54 |
Tank emptying problem using Ansys Fluent
|
#1 |
Senior Member
Tanjina Afrin
Join Date: May 2013
Location: South Carolina
Posts: 169
Rep Power: 13 |
Hello,
I am modeling a reservoir-pipe system, where with time water from reservoir will drain out through pipe. I am using Ansys Fluent. I think it's pretty common simulation. But I have one confusion. For top of the reservoir, what BC should I use ? Wall BC ( I assigned one zone above the top of the reservoir ar patched that zone with air) , or should I use pressure inlet and allow air to enter ? Any suggestion will be highly appreciated. Regards, Tanjina |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ansys 12.1 - Create Rotor/Stator Interface for Fluent | opm | ANSYS Meshing & Geometry | 21 | May 23, 2016 08:29 |
problem in using parallel process in fluent 14 | aydinkabir88 | FLUENT | 1 | July 10, 2013 02:00 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
Fluent & Ansys FSI architecture help | DillonS | FLUENT | 1 | April 7, 2010 16:00 |
Can FLUENT solve this type of problem? | Whitaker | FLUENT | 3 | October 23, 2000 03:01 |