|
[Sponsors] |
February 3, 2015, 12:11 |
FLUENT start up command line
|
#1 |
New Member
B. F
Join Date: Feb 2014
Posts: 5
Rep Power: 12 |
Hi!
I am trying to run a case file on a cluster and I need to edit this line of the the file that submits the case to the custer: ## Put correct parameters in fluent execution line ## below: fluent 2d -g -ssh -pdefault -t${cpus} -i cav.jou This line is just used for an example case. My case is 3D and I dont need a JOU file, so I have edited this line as: fluent 3d -g -ssh -pdefault -t${cpus} Fluent is returning the following error: > Halting due to end of file on input. What am I doing wrong? Thank you so much. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Info message -> Fluent does not start | Jenson | FLUENT | 0 | December 22, 2011 17:21 |
Automatically start new calculation after the one before is completed? (FLUENT 12.1) | mars21t | FLUENT | 4 | March 27, 2011 09:52 |
How to start fluent by c++ languang? | xinyijunlinrui | FLUENT | 0 | January 22, 2011 22:43 |
Cannot start fluent with command line | ozzythewise | FLUENT | 2 | October 24, 2010 14:25 |
Can Fluent start a simulation from a negative time | Ted Chu | FLUENT | 10 | November 26, 2008 21:06 |