|
[Sponsors] |
Enhanced wall treatment, low re k-e model, k-w model with low Re correction |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 21, 2015, 16:36 |
Enhanced wall treatment, low re k-e model, k-w model with low Re correction
|
#1 |
New Member
junz
Join Date: Oct 2014
Posts: 13
Rep Power: 12 |
Hi all,
I have questions regarding on the mesh and near wall treatment selection: If I a refined boundary layer mesh and I choose k-epsilon model, then what is the near wall treatment should I choose? Or How fluent will work with this case? If I choose enhanced wall treatment, is it that two layer model will applied to resolve turbulent quantities (with inner layer using a one equation model to compute turbulent viscosity while for the outer layer turbulent viscosity is computed from governing equations) ? But I am confused if I enable low Re k-epsilon model, does it mean the the turbulent viscosity is computed all the way from the wall from governing equation? And what's the case for k-w model? If I choose low Re correction, it works the same like low Re k-epsilon model? While without choosing, it just applies the two layer model computing turbulent quantities? Thanks. |
|
Tags |
enhanced wall treatment, k-w, low re correction, low re k-e |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Enhanced wall treatment in OpenFOAM | Super Mario | OpenFOAM Running, Solving & CFD | 2 | December 4, 2016 03:39 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 06:36 |
wall treatment k-w SST model in Fluent | behest | FLUENT | 0 | December 26, 2014 09:14 |
Near wall treatment in Solidworks....turbulence model | nikesh | FloEFD, FloWorks & FloTHERM | 2 | January 13, 2014 22:44 |
Boundary Layer roughness/ low reynolds wall treatment | Luigi_ | STAR-CCM+ | 1 | March 14, 2012 09:40 |