|April 30, 2015, 09:14||
DPM accretion rate & cell/nodes value
Join Date: Apr 2015
Posts: 28Rep Power: 3
Hello everyone !
When i display the contours on the stream trajectory of the accretion rate, I've observed that I obtain non zero values on the last cell contained between mesh edges and one between the last edge and the wall : why ?
Also it seems that I display the correct value when I activate node values but without node value (so cell value), the accretion rate is twice as big as I anticipated. I don't undestand why, and how could I write a file with the node value only ?
Thank you very much for your time !
|Thread||Thread Starter||Forum||Replies||Last Post|
|Integral DPM Accretion on Wall||Fabio||FLUENT||3||March 5, 2014 12:32|
|DPM flow rate||sfotovati||FLUENT||0||November 5, 2013 20:42|
|DPM mass flow rate||sajeesh||FLUENT||6||May 7, 2013 05:46|
|Dpm injection mass flow rate||diamondx||FLUENT||0||November 22, 2012 14:04|
|DPM injection mass flow rate||kingpots||ANSYS||0||November 22, 2012 12:12|