|
[Sponsors] |
May 11, 2015, 03:53 |
Parameter Output Problem
|
#1 |
New Member
Join Date: Dec 2014
Posts: 4
Rep Power: 11 |
Hey everyone,
I analysed a problem using Ansys Fluent and I want to extract some Output Parameter at a specific Point.The problem is when I create the point and compute the parameter(Surface total heat transfer) and save it as a output parameter it disappear in workbench parameter panel.when I go and check the fluent I see that the output parameter is gone.I have the same problem with Iso-surface Parameters too can anyone help me. |
|
Tags |
fluent, parameterization |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2 Way FSI Problem | alialibas | CFX | 23 | July 20, 2016 18:59 |
writing execFlowFunctionObjects | immortality | OpenFOAM Post-Processing | 30 | September 15, 2013 07:16 |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 23:03 |
CFX-5.7 MPICH Parallel Problem (Output of Results) | James Date | CFX | 7 | February 15, 2005 17:03 |
ICEM5 Hexa output problem | Pete | CFX | 9 | September 16, 2004 19:33 |