|
[Sponsors] |
August 6, 2015, 04:22 |
Error of Interface
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
I am simulating a turbine and I had explained this model and boundary conditions in the following link: http://www.cfd-online.com/Forums/flu...tml#post558380 This turbine have 6 blades((360/6)=60 deg=angle between blades). Due to the circumferential symmetry, only one sixth of the annulus has been computed, imposing periodic boundary conditions in the tangential direction. The computational domain has been restricted in the axial direction to four chord lengths upstream and six chord lengths downstream of the blade. So, I had created periodic condition in Gambit, But when I watched the following video, I think that I should create two Interface. http://www.4shared.com/video/VwtSUbM...Blade_FSI.html However, I made two wall in circumferential sides of the domain by using Gambit. Then, I defined these two walls to interface in fluent. But when I want to initialize in The Solution Initialization panel, I face the following error: Why does this happen? Thanks, Best, Aja |
|
August 9, 2015, 23:59 |
|
#2 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
Dear friends, I clicked the following options: Define>grid interfaces.. according the following figure, I done these works: But when I click option of List in above figure, the following sentence is appeared: *intersection zones are not created until initialization* Why? I am grateful that guide me. Thanks, Best, Aja |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |