|
[Sponsors] |
October 19, 2015, 09:28 |
Increasing the number of nodes in fluent
|
#1 |
New Member
SATYAJIT SHUKLA
Join Date: Jun 2015
Posts: 9
Rep Power: 10 |
I m using a case file developed by other user. I need to increase number of nodes in mesh. Please tell me the process in ansys fluent 15 or any other software.
Is there any setting or tool by which i can increase number of nodes in fluent mesh generation mode. Last edited by satya9889; November 3, 2015 at 00:05. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
[blockMesh] --> foam fatal error: | lillo763 | OpenFOAM Meshing & Mesh Conversion | 0 | March 5, 2014 10:27 |
[ICEM] Dissociate blocks number of nodes | gi12 | ANSYS Meshing & Geometry | 2 | February 23, 2012 22:33 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |