 |
 |
 |
|
|
|
[Sponsors] | ||||
How to apply heat flux at the interface when using VOF method? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 15, 2015, 08:47
|
How to apply heat flux at the interface when using VOF method?
|
#1 |
|
New Member
Join Date: Apr 2015
Posts: 5
Rep Power: 12  |
I track the transient interface in my model using VOF method. And I need to apply a heat flux at the interface.
As we know, in the VOF method, the interface is obtained through reconstruction. I need to convert the heat flux (unit:W/m2) to a volume heat (unit: W/m3) and apply it at the interface cell. Is there any function to convert the heat flux to a volume heat for volume method? |
|
|
|
|
|
| Tags |
| heat flux, interface, vof method |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 20:43 |
| Heat Flux Profile at Fluid-Porous Interface | Hitch8 | CFX | 4 | December 15, 2012 10:57 |
| heat flux on fluid-solid interface does not match | Dai | CFX | 4 | October 30, 2006 09:38 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |
Linear Mode
