|February 19, 2016, 18:55||
Join Date: Apr 2015
Posts: 32Rep Power: 4
I have a simulation that consist of two parallel heated wall and blowing air between them. Flow is turbulent and attached picture, you can see the y+ contours on one of two walls. Although y+ value should decrease along x direction as flow gets developed, there is a region that shows an increasing. ( I enclosured in the picture). For this reason I have a heat transfer coefficient distribution that decreases from start point naturally but increases at that region then decreases again after that region.
What may cause this region ? Thank you for your precious comments.
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF compiling problem||Wouter||Fluent UDF and Scheme Programming||6||June 6, 2012 04:43|
|Gambit - meshing over airfoil wrapping (?) problem||JFDC||FLUENT||1||July 11, 2011 05:59|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|
|Is this problem well posed?||Thomas P. Abraham||Main CFD Forum||5||September 8, 1999 14:52|