Home > Forums > Software User Forums > ANSYS > FLUENT

Not able to see the 'trap' condition for a BC on a surface

Mark Forums Read

Reply

Search this Thread

March 27, 2016, 04:34	Not able to see the 'trap' condition for a BC on a surface	#1
Kartik_Sharma New Member Lolwa Join Date: Mar 2016 Posts: 1 Rep Power: 0	Hello, I am new to fluent. I wanted to find the number of particles sticking in a deposition over a cylinder. I am not able to see the choose the BC option for the outer cylinder surface (where the trapping should happen) Thanks in advance!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Spillway Analysis Fixed Water Surface Boundary Condition	mgdenno	OpenFOAM Running, Solving & CFD	17	December 9, 2018 18:37
boundary condition of an internal surface	ynsudo	OpenFOAM Running, Solving & CFD	7	September 14, 2011 05:17
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 13:43
boundary condition at free surface	mike	Fidelity CFD	3	June 8, 2006 07:23
Boundary condition of free surface model	Tony	FLUENT	3	September 27, 2004 14:48

All times are GMT -4. The time now is 21:06.