|
[Sponsors] |
June 1, 2016, 05:36 |
Incomplete particles
|
#1 |
New Member
Prashanth
Join Date: Jun 2016
Posts: 20
Rep Power: 9 |
Hii..
Actually am trying particle tracking method. am getting particles at the outlet when i increased the number of flow cycles. in my simulation 0 to 20s is one pulse(cycle). However, particles are following fluid time step. After completion of one cycle still particle are at the inlet, just they travel few steps from the inlet. Really am confused with particle time step and fluid time step. If i increase the number of pulse cycles(30) in the fluid domain setting means particle will travel upto end. Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Small particles are always incomplete !! | souria | Fluent Multiphase | 5 | May 9, 2016 08:44 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Fluent DPM - incomplete particles | richard ben | FLUENT | 4 | September 26, 2014 11:37 |
Problems building Paraview 3.12 on Gentoo Linux | pajot | OpenFOAM Installation | 11 | April 11, 2013 08:09 |
[swak4Foam] installing funkySetFields | igo | OpenFOAM Community Contributions | 1 | November 20, 2012 20:16 |